Europlex SigNET 300 Guide de l'utilisateur

SigNET 200/300 User Guide

Page 10 3.5 Unsetting the System To UNSET an armed system enter your user code on the keypad. The Keypad display will prompt the user to unset the

Page 11 3.8 Inhibiting a Zone The user has the option to manually inhibit a Zone on the system from the keypad. The Inhibit operation is active for

Page 12 3.10 Isolating a Zone or fault The user has the option to manually isolate a zone or fault on the system from the keypad. Isolating a zone

Page 13 3.12 Performing Tests on the system The user has the option to perform simple tests on the system to determine if the bells, buzzers and

Page 14

Page 2 COPYRIGHT NOTICE Copyright © 2006 Europlex Technologies Ltd (hereby referred to as Europlex). All rights reserved. No part of thi

Page 3 Table of contents 1. Introducing the SigNET 200/300 System ...4 2. How to use your Key

Page 4 1. Introducing the SigNET 200/300 System The SigNET 200/300 system must be installed by a qualified installation engineer. When the installa

Page 5 2.1 How to use the Keypad programming interface TOP LINE OF DISPLAY During the IDLE state this line will show the current date and time.

Page 6 2.2 Data entry on the SigNET Keypad Entering data and navigating the menus on the Signet Keypad is facilitated through the use of the progr

Page 7 3. Intruder alarm Operation The operational features of the SigNET 200/300 system are described below. Your installation engineer will info

Page 8 Menus These Menu options are only available to Standard or Manager Type Users. INHIBIT Inhibiting a zone will de-activate that zone f

Page 9 3.1 Entering User Programming To access user programming simply enter the user code given to you by the installation engineer on the keypad